Working volume: X 2020mm x Y 1015mm x Z 400mm. The below is my CNC setup:ĭesign software: Aspire and highly considering Fusion 360.ĬAM software: Mach3, (may consider to switch to UCCNC if no solution is found for laser).ĬNC driver system: CNCDrive servo drives +UC300ETH-5LPT Ethernet motion controller, capable of having 2 dedicated PWM outputs - 1 for the router and the other for the laser. Although it would be nice to have that option, it doesn't really bother me as I am mainly interested in cutting. Since I am using UCCNC drives, from my search results so far, it seems that photo engraving is out of reach to be done on a CNC setup such as mine. I am currently fitting a co2 laser on my second build and while slowly progressing on the physical work, at the same time am doing research on how to cross over from design to manufacture.
I have been working with self built CNC router as a hobbyist for quite a number of years.
I'm new around here and have been reading this post which I have found very helpful.
First, the PP is the original one that Seth so credit really is to him, I just made a couple extra changes to his good workĭoes the code below work for you ? If yes then try the attached PP, it is 3 different Profiles and seems to do what you are asking about